NSN 5310-01-244-4517 CPS-443-0060 IT85, CPS4430060IT85, 805-1400052 PIECE 19

5310-01-244-4517 A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.

Part Alternates: CPS-443-0060 IT85, CPS4430060IT85, 805-1400052 PIECE 19, 8051400052PIECE19, 8100-1251-0192 PC 160, 810012510192PC160, 8100-1251-0307 PC NO 118, 810012510307PCNO118, 1-1/4 OD X 25/3 2 ID X 1/16 THK, 114ODX2532IDX116THK, 124-4322611 PC 21, 1244322611PC21, 124-4322615 PC5, 1244322615PC5, 1520-22 PC 21, 152022PC21, 1520-26 PC5, 152026PC5, 167-6926161 PC118, 1676926161PC118, 167-6926163 PC73, 1676926163PC73, 167-6926165 PC78, 1676926165PC78, 4322611, 4322615, 5310-01-244-4517, 01-244-4517, 5310012444517, 012444517

Hardware and Abrasives | Nuts and Washers